EREAGLE Ere-E1S - Audio Settings; Trigger Alarm Settings; Time and Date

20
Video Length time 1~120s Video recording length of time, unit: second 10s
Max Shooting Number 0~255 Limit the number of daily shooting, 0 means no limit. 0
4.5. Audio settings
This function is used to for sound recording, turn on and off for button and power-on tone.
Audio
Audio Record
Single
selection
ON Open to record audio and video Sync default
OFF OFF
Boot Sound
Single
selection
ON Open the boot sound default
OFF OFF
Key Sound
Single
selection
ON Open the buttons hint sound default
OFF OFF
4.6. Trigger alarm settings
Our camera includes pre-sensor PIR and shooting PIR.When the heat source moves the object into the
PIR pre-induction area, the camera immediately enters the start-up state; when the shooting PIR is triggered,
the camera quickly shoot. This method can be more accurately capture the target object.
Users can adjust the trigger interval and induction sensitivity according to the frequency of animal
activity, this can prevent repeated capture and get the more accurate data.
Alarm
trigger
PIR Mode Single selection
Main PIR Only open Main PIR
Main&Side PIR Open Main and side PIR default
OFF All OFF
Sensitivity Single selection Auto
According to the environmental
temperature automatic adjustment
default
Interval Number
Low lowest
Normal normal
High highest
0sec-59min
the interval of next trigger after the
previous trigger.
One min
4.7. Time and date
Set time and date, to be local time synchronization, in order to accurately capture the target activity time.
So before use the camera, please set the time and date according to local accurate time and date.
Manual setting: The user can directly set the date and time in the menu. You can also set the date and
time display format.
Auto Acquisition Time & Date: The camera automatically obtains the time and date via the Internet
after each start. This function needs to set NTP parameters.
Time
and
Date
Time Format Single selection
12hours display： 6:42:54pm
24hours display：18:42:54 default
Date Format Single selection
YYYY-MM-DD 2014-11-6
MM/DD/YYYY
11/6/2014
default
DD/MM/YYYY 6/11/2014
Setup Time date and time
2014-11-6
18:42:54
If you need to manually set the date
and time, please set Auto off.
Automatic acquisition time and date is only for mms camera ERE-E1S
The date and time set manually will be lost when the battery taken out for 20 seconds.