EREAGLE Ere-E1S - Night Lighting; Telecommunications

22
4.10. Night lighting
This setting helps to improve the effect of insufficient light illumination change at sunrise and sunset.
Correct setting of this parameter can improve the shooting effect. Here you can set the day/night automatic
switching, night mode or day mode. In night mode, you can also set the light level to control the photo
brightness.
We provide three different lighting source, the user can choose according to your need
940nm invisible infrared light source: high power invisible light source, ultra-low red exposure, night
vision distance can reach up to 30 meters.
850nm invisible infrared light source: high power invisible light source, visible red exposure, night
vision distance more than 40 meters.
650nm visible white light source: high-power white light source, visible white light, night vision
distance more than 30 meters.
Night
Vision
Night Vision Mode Single selection
Auto
Auto detect day and night mode
Default
Day Always on day mode
Night
Always on night mode
Light Level Single selection
Standard The IR LED current to 900mA. Default
Plus The IR LED current to 1300mA.
4.11. Telecommunications
When the PIR trigger shooting, the camera will automatically send SMS(short messages), MMS or
e-mail to the specified recipient. Our camera supports 3 different transmission methods.
SMS: by sending text messages to the phone to notify the user.
MMS: by sending pictures to the phone to notify the user. You need to set the MMS parameters and
receiver information correctly.
GPRS: by sending pictures to the mailbox to notify the user. You need to set the SMTP parameters and
recipient information correctly.
Off: Close all communication related functions.
GSM
Setting
Select Network Operators
Send Mode
single
selection
MMS Send by MMS
SMTP
Send by Email
OFF Turn off Communication Default
Send Number Digital 0~255
Limit the maximum number of messages
sent per day. Bit 0 is not restricted.
10
Daily Report
single
selection
ON Send 1 daily report per day
OFF
Don’t send
Default
MMS Parameter It is used to Setting MMS related Parameter and receiver information.
SMTPS Parameter
It is used to Setting SMTP related Parameter and receiver information.
Remote control
Single
selection
ON support
OFF
Not support
Default