Cleaning and maintenance
07/2015 1015722-00B Operating instructions – 59/84
AFFINITY 700 ADVANCED PERFORMANCE/
AFFINITY 700 ADVANCED PERFORMANCE (TP)/
AFFINITY 700 ADVANCED PERFORMANCE AC PLUS:
These devices have 2 UV low pressure lamps in the facial tanner.
The facial tanner's UV low pressure lamps must be removed first so that the
UV high pressure lamps can be changed.
– Remove the lamps.
AFFINITY 900 ADVANCED PERFORMANCE AC PLUS/
AFFINITY 990 DYNAMIC PERFORMANCE AC PLUS:
These devices have 3 UV low pressure lamps in the facial tanner.
– Remove the lamps.
– Remove the two upper low pressure lamps in the canopy so that you can
then access the facial tanner's low pressure lamp starter.
Replacing lamps: see page 54.
Replacing starters: see page 55.
UV high pressure lamps and filter panels: see page 56.
The assembly is the same process in reverse order.
When assembling the device please note:
– Support the canopy panel with one hand so that it does not fall down.
– Re-lock the locks: first the lock in the middle, then the outer locks.
To Next Page
Loading...
