AXX 9100 CONNECT R1.2 Quick Reference Guide
3/1531-ZAP 701 14/1 Uen A 2006-10-16
28
Figure 13 Inserting an SFP module into an SFP module slot
4. Remove the dust plugs from the optical ports on fiber-optic SFP
modules and store them for later use.
NOTE! When you are ready to connect the cable, remove the dust
plugs from the fiber-optic SFP module port and the rubber
caps from the fiber-optic cable. The plugs and caps protect
the SFP module ports and cables from contamination and
ambient light.
1.9.3.2 Removing SFP modules
To remove an SFP module from a module slot, follow these steps:
1. Disconnect the cable from the SFP module.
TIP! Note which connector plug is send (TX) and which is receive
(RX) in case you reattach the of fiber-optic cables.
2. Insert a dust plug into the optical ports of fiber-optic SFP
modules.
3. Use your index finger to pull the bale out and down to eject the
module.
Figure 14 Bale-Clasp Latch
To Next Page
Loading...