STORE 1
Name:_
2. To store a phone number in the first
free memory position (1 in this example),
go to point 5, below.
3. To store a phone number in a different memory
position, press Left Arrow.
STORE _
Name:_
4. Enter the number of the memory
position (one or two digits), for
example 10, and press Right Arrow.
STORE 10
Name:_
5. To store a phone number without a
name, press YES.
Go to point 8, below.
6. Enter the first letter of the name by pressing the
appropriate numeric key as many times as required.
STORE 10
Name:S_
When an underline character (_)
appears to the right of the letter entered,
you can enter the next.
If you want to enter a space, press the 1 key. To enter a
hyphen, press the 1 key twice.
If you make a mistake, when entering the letters,
you can correct it with the CLR key.
STORE 10
Name:STUART_
7. When you have entered the name,
press YES.
STORE 10
Name:STUART
Enter no: _
8. Enter the phone number and press
YES.
STORED 10
Name:STUART
+46412345678
9. The name and number is stored.
Alternative Method to Store a Phone Number
+46412345678
If the phone number you wish to store, is
shown in the display
PHONE BOOK
< Store >
1. Proceed as described under points
1 -- 7 in the preceding section.
STORED 10
Name:STUART
+46412345678
2. The number and name is stored.
Memory Protection
STORE 10
Used
Overwrite?
If you try to store a phone number in a
memory position which already contains
a phone number:
a. Store the number in a different memory position.
Press NO and enter the number of the memory
position.
5. Using Menus
38
To Next Page
Loading...
