Ericsson R320S - Page 65

N
o
t
f
o
r
C
o
m
m
e
r
c
i
a
l
U
s
e
E
r
i
c
s
s
o
n
M
o
b
i
l
e
C
o
m
m
u
n
i
c
a
t
i
o
n
s
A
B
Communicating via the Built-in Modem 65
You can alternate between using infrared communication or an external
RS232 cable when communicating with your PC. Every time you want to
change between infrared and cable communication, you need to start the
Setup Assistant.
To switch communication mode
1. Make sure you have gone through all the steps in “To install the built-in
modem on the PC” on page 63.
2. Double-click the file Troubleshooter for R320.bat
, which you can find
on your computer under C:/Program files/Ericsson/Communications Suite.
3. When the Setup Assistant is started, it asks you to select a connection type:
Infrared or Cable. Choose the one you want to change to.
4. The Setup Assistant then helps you make the correct settings (and helps
you install any missing components if necessary).
If you have connection problems between your mobile phone and your
computer despite proper installation, you can start the Setup Assistant.
This is the program that analyzes your computer, and helps you install any
missing components.
To start the Setup Assistant
Double-click the file Troubleshooter for R320.bat, which you can find on
your computer under:
C:/Program files/Ericsson/Communications Suite/Troubleshooter for
R320.bat
To make sure you get the most out of your built-in modem, follow these
guidelines:
• You can break infrared communication between your mobile phone and
computer for a short while (approximately 15-20 seconds) without
interrupting the connection. You can configure your computer to make a
warning sound when the mobile phone is removed from its reach. Make
sure you place your mobile phone back in position within the time limit in
order to remain connected.
• Strong sunlight can interfere with the infrared light. To ensure a stable
connection, keep the connecting devices away from sunlight.
Switching Between Infrared Communication and Cable
Communication
Solving Connection Problems After the Installation
Tips on Using the Built-in Modem