EasyManua.ls Logo

Ericsson R380s - Page 176

Ericsson R380s
214 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
176 Extras
9.
To enter or change whether the IP address assignment is
performed automatically from the server or remains static
according to the setting in the Own IP-address section, select
IP
assignment:
and then select
Server
or
Static
.
10.
To enter or change whether the DNS IP address assignment is
performed automatically from the server or remains static
according to the settings in the Primary DNS or Secondary
DNS sections, select
DNS assignment:
and then select
Server
or
Static
.
11.
To enter or change the static IP address for the R380s, select
Own
IP address:
and enter a new IP address.
12.
To enter or change the static primary DNS IP address for the
R380s, select
Primary DNS:
and enter a new primary DNS IP
address.
13.
To enter or change the static secondary DNS IP address for the
R380s, select
Secondary DNS:
and enter a new secondary DNS IP
address.
14.
To change the secure username (only available if sent by your
service provider), select
Secure username:
and make your change.
Warning! You are advised not to make changes to the secure
username, except when directed by your service provider.
15.
Tap to implement and save the new settings. The display
returns to the Preferences view.
Port settings
To change the port settings:
1.
Select
Port
from the list displayed in the Settings view. The Port
settings view appears in the display.
2.
To change the baud rate of the serial port, select
Baud rate
and then
select
2400
,
4800
,
9600
,
19200
,
38400
,
57600
or
115200
.
3.
To change the parity checking for the serial port communication,
select
Parity:
and then select
None
,
Odd
,
Even
,
Mark
or
Space
.
4.
To change the number of stop-bits for the serial port
communication, select
Stop bits:
and then select
1
or
2
.
5.
To change the number of bits per character for the serial port
communication, select
Character length:
and then select
5
,
6
,
7
or
8
.
6.
To change the flow control protocol for the serial port
communication, select
Flow control:
and then select
CTS/RTS
or
XON/XOFF
.
OK

Table of Contents

Other manuals for Ericsson R380s

Related product manuals