Getting Started 9
When to charge the battery
When the battery needs to be charged, a beep is heard, the indicator
light (on the top of your R380s) blinks red and a battery low message
appears in the display. The battery can also be charged whenever you
wish without affecting the R380s’s performance.
Note: The R380s automatically switches off if the voltage is too low.
Charging
Charge the battery by using the charger supplied with your R380s.
You can use some battery chargers that have been supplied with other
Ericsson mobile phones using the same connector plug, e.g. T28,
R320s.
Warning! Avoid direct sunlight. Extremely high temperatures reduce
the capacity of the battery permanently. Avoid recharging a full or
almost full battery.
Battery removal and insertion
To remove the battery:
1.
Ensure that the flip is closed.
2.
Ensure that your R380s is turned off.
Warning! It is important that you always turn off your R380s before
removing the battery. Failure to do so will result in loss of
information.
3.
Push up the release catch at the top of the battery and lift the
battery away from your R380s.
To insert the battery:
1.
Ensure that the flip is closed.
2.
First place the bottom of the battery into position and then push
the upper section of the battery until it clicks into place.
To Next Page
Loading...
