EasyManuals Logo

Ericsson T28s Troubleshooting Guide

Ericsson T28s
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
Trouble Shooting Guide, Standard
4/00021-2/FEA 209 544/19 E 25(29)
9 Alert Problems
9.1 Type of fault
Insert a dummy battery and a SIM-card into the phone and start it up by pressing the On/Off
key. Wait for the phone to get SERV (towards the test instrument or the net).
If the phone does not beep at start-up, use the menu to increase the ring volume (not from full
to “step”, as that does not generate any sound).
If the sound is faint or there is no sound at all, go to section 9.2.
Use the menu to set the vibrator to ON mode. If the phone does not vibrate when the settings
are stored, go to section 9.4.
9.2 Buzzer faint or dead
Open the phone and check for liquid damage.
Make sure the buzzer (H600) is not incorrectly soldered.
If the solder joints are correct, replace H600.
Assemble the phone and try again as described in section 9.1.
Open the phone, power up the board and start it by pressing the On/Off key.
Measure the voltage at pin 3 of H600 (3.70 ±
0.05 V).
If the voltage is incorrect, replace R603.
If that does not help there is a foil damage, send the unit on according to the local company
directives.
Measure the resistance of R651 (1 kohm).
If the resistance is incorrect, replace R651.
If the resistance is correct, replace V606.
If that does not help, replace V605.
If the fault remains, send the unit on according to the local company directives.

Other manuals for Ericsson T28s

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ericsson T28s and is the answer not in the manual?

Ericsson T28s Specifications

General IconGeneral
BrandEricsson
ModelT28s
CategoryCell Phone
LanguageEnglish

Related product manuals