ero electronic TMS - Default Configuration Parameters

A. 2
DEFAULT CONFIGURATIONDEFAULT CONFIGURATION
DEFAULT CONFIGURATIONDEFAULT CONFIGURATION
DEFAULT CONFIGURATION
PARAMETERSPARAMETERS
PARAMETERSPARAMETERS
PARAMETERS
The configuration parameters can be loaded with
predetermined default values. These data are the
typical values loaded in the instrument prior to
shipment from factory. To load the default values
proceed as follows:
a) The internal switch (V2, see fig. 13) should
be open.
b) The upper display will show:
c) Push the  pushbutton; the lower display will
show the firmware version.
d) Maintaining the pressure on the  pushbutton
push the  pushbutton also.
The instrument will show
e) Press  pushbutton to select between table 1
(european) or table 2 (american) default
parameter set. The display will show:
f) Press FUNC pushbutton; the display will show:
This means that the loading procedure has been
initiated. After about 3 seconds the loading
procedure is terminated and the instrument
reverts to visualization as in point b).
The following is a list of the default parameters
loaded during the above procedure:
PARAMETER TABLE 1 TABLE 2
P1 1 9
P2 0 °C 0 °F
P3 400 °C 999 °F
P4 H H
P5 rEL rEL
P6 Air Air
P7 1 1
P8 HA HA
P9 OFF OFF
P10 0 0
P11 HA HA
P12 OFF OFF
P13 0 0
P14 0 0
P15 0 0
P16 OFF OFF
P17 10 A 10 A
P18 0 0
P19 rEv rEv
C n FC n F
C n FC n F
C n F
C n FC n F
C n FC n F
C n F
A. 0 1A. 0 1
A. 0 1A. 0 1
A. 0 1
O F FO F F
O F FO F F
O F F
d F L d F L
d F L d F L
d F L
t b. 1t b. 1
t b. 1t b. 1
t b. 1
d F L d F L
d F L d F L
d F L
L. d t.L. d t.
L. d t.L. d t.
L. d t.
TMS-A-01.pmd 16/02/2005, 14.392