Erreka DINGO - Programming Functions; Turning direction change and check; Total opening radio code programming; Pedestrian opening radio code programming

7
P71Y
P71X
P71Z
Turning direction change and check (C1)
P71V
P71W
This operation is only necessary if the operator opens the leaf instead of closing it when making a reset (rS).
I
II
P157E
Total opening radio code programming P1 (with RSD receiver only, C801)
 If a receiver other than
RSD
is used, see the cor-
responding instructions.
Select the option C801
(RSD receiver) before
starting programming.
Pedestrian opening radio code programming, P2 (with RSD receiver only, C801)
This procedure is the same as for total opening, but using parameter P2 instead of P1.
I
II
O Wait whilst the gate
carries out the
open/close
Open/close programming (P3)