4.2.2 Levelling the heated bed
The recommended distance between the nozzle and printing surface is
0.05~0.1mm(Thickness of A4 paper). There are 4 knobs under the
heated bed, by which you can tighten or loosen the springs to reduce
or increase the distance between the nozzle and printing surface.
The distance from nozzle will increase if you tighten knobs, otherwise,
it will decrease distance from nozzle.
Step1: Click “Prepare”→“Auto home”→“Disable steppers”
Step2: Manually move the extruder to the 1
st
right hand corner of the
heated bed, you need to place a piece of A4 paper between the nozzle
and the heated bed, fine-tuning until you feel slight friction from the
paper when you pull on it(Repeat for all 4 corners and centre of the
bed)
10
To Next Page
Loading...
