Eryone Thinker S - LCD Interface and Controls

6. LCD layout
This section is for LCD layout. Items not mentioned below are not used
for the common print setup-you should not change any of the
unmentioned items unless you are absolutely sure what you are doing.
□ Info screen
□ Prepare
□ Move axis
□ Move X
□ Move Y
□ Move Z
□ Auto home
□ Home X
□ Home Y
□ Home Z
□ Bed leveling
□ Level bed
□ Fade height
□ Bed Z
□ Loading settings
□ Store settings
□ Set Home offsets
□ Disable steppers
□ Change filament
□ Preheat PLA
□ Preheat PLA End
□ Preheat PLA Bed
□ Preheat ABS
□ Preheat ABS End
□ Preheat ABS Bed
17