Eryone Thinker S - Advanced Features and Troubleshooting; Power Loss Resume Feature; Auto-Leveling Sensor Support; FAQ

To Next Page

To Previous Page

7.6 Power failure protection

Power failure resume feature: Built-in supercapacitor and circuit

designing, the mainboard will store the height value of Z-axis when the

power off. When the power system resume, the printer can resume the

print.

7.7 Compatible with auto-leveling sensors(Not included

sensor)

With pre-designed interface for BL-touch and proximity switch, update

Eryone Thinker S firmware to enable the auto-leveling function is easily.

8. FAQ-Common Assembly issues

8.1 X carriage is loose

If you find your X carriage is loose. You can use the wrench to tight the

eccentric nut this will remove wobble and slack in the X carriage.

8.2 Z axis stop moving or stick half way

1) Check if the stepper motor cable is loose

2) You need to check your wires at first. If it is ok, you can loossen the

brass nut screw a little, this will help it move correctly.

3) Add the lubricant oil to the T8 rod

Eryone Thinker S - Advanced Features and Troubleshooting; Power Loss Resume Feature; Auto-Leveling Sensor Support; FAQ - Assembly Issues