Why is my ESAB Welding System giving poor welding performance?
If you're experiencing poor welding performance with your ESAB Welding System, first ensure that the welding current supply and return cables are correctly connected. Also, verify that you're using the correct current value and electrodes. Finally, check the gas flow to ensure it's adequate for your welding needs.
What to do if the thermal protection trips frequently on my ESAB Welding System?
If your ESAB Welding System's thermal protection trips frequently, start by checking if the dust filter is clogged. Additionally, ensure that you are not exceeding the rated data for the power source, meaning the unit is not being overloaded.
What to do if the welding current is interrupted during welding with my ESAB Welding System?
If the welding current is interrupted during welding with your ESAB Welding System, first check whether the thermal protections have tripped, indicated by the orange lamp on the front panel. Also, examine the mains power supply fuses to ensure they are in good condition.
How to troubleshoot no arc on ESAB Welding System?
If your ESAB Welding System has no arc, begin by checking that the mains power supply switch is turned on. Then, verify that the welding current supply and return cables are correctly connected. Ensure that the correct current value is set and check to see whether the MCB has tripped.
General| Brand | ESAB |
|---|---|
| Model | Caddy Arc 201i |
| Category | Welding System |
| Language | English |
Recommendations for wearing personal protective equipment.
Guide to performing MMA welding with the equipment.
Instructions for performing TIG welding with the equipment.
General safety precautions for operating welding equipment.
Detailed warnings and cautions covering electric shock, fumes, arc rays, fire, noise, and usage.
Instructions for connecting welding and return cables.
Guide to MMA welding procedures.
Guide to TIG welding procedures and required equipment.
Recommended checks for common operational faults.
Explanation of fault codes displayed by the built-in diagnostic system.
To Next Page