ESAB EAC 10 - Introduction to the EAC 10 Control Unit; Equipment Description

2 INTRODUCTION
0463 609 101
- 7 -
© ESAB AB 2020
2 INTRODUCTION
EAC10 is a control unit intended for submerged arc welding (SAW) and for gas metal arc
welding (GMAW). The control unit is included in VersotracEWT1000 and can be used to
control automated welding equipment, for example welding portals, column and booms. The
control unit can be used with the following ESAB CAN based power sources: LAF, TAF and
Aristo®1000.
For information about the control panel EAC10 features, refer to the control panel instruction
manual.
For general information about operation, see the instruction manuals for the power source.
ESAB accessories for the product can be found in the "ACCESSORIES" chapter of
this manual.
2.1 Equipment
EAC10 can be connected to ESAB CAN based (digital) and compatible analogue based
power sources. EAC10 control unit consists of:
• Motor drive unit – contains control electronics to drive the wire feed and carrier motors.
• Control pendant – provides a user interface to select the desired settings.
The control unit is supplied with:
• A control pendant holder with screws
• An instruction manual for the control unit
• An instruction manual for the control panel
A USB memory is available as accessory, see the "ACCESSORIES" chapter of this manual.
Instruction manuals in other languages can be downloaded from the Internet: www.esab.com