ESAB EM 215ic - Page 9

2 INTRODUCTION
0463 408 001
- 9 -
© ESAB AB 2017
EM series
• ESAB EM 215ic power source
• ESAB MXL 200 MIG torch, 3m (10ft)
• Contact tip M6 for 0.8mm (0.030in.) wire (qty 2)
• Contact tip M6 for 1.0mm (0.040in.) wire (qty 2)
• Gas hose, 4.5m (14.8ft), Quick connector
• Return cable kit 3m (10ft)
• OK 12.50 0.8mm(0.030in.) ×5kg (11lb) bobbin
• Drive roll: 0.6 / 0.8 mm (0.023in. / 0.030in.) Cored, Steel and Stainless wire
(installed on drive system)
• Drive roll: 0.8/1.0mm (0.030in. / 0.040in.) Cored, Steel and Stainless wire (in
accessory box)
• Guide tube 1.0mm – 1.2mm (0.040in. – 0.045in.) (installed on drive system)
• Guide tube 0.6mm – 0.8mm (0.023in. – 0.030in.) (in accessory box)
• Mains cable 3m (10ft), fixed with plug
• Safety manual
• USB with Operator's Manual
• Material thickness guide