Why is my ESAB Rustler EM 201C Welding System performing poorly?
Poor welding performance with your ESAB Welding System can occur if welding current supply and return cables aren't correctly connected, the current value isn't set correctly, the welding wires being used are incorrect, or the main power supply fuses are faulty. Ensure all these components are properly checked and set up.
How to fix no arc on ESAB Welding System?
If your ESAB Welding System has no arc, start by checking that the mains power supply switch is turned on. Then, check that the mains, welding, and return cables are correctly connected. Ensure the correct current value is set and inspect the mains power supply fuses.
How to fix slow wire feed on ESAB Rustler EM 201C?
If the wire feed is slow or stiff through the wire feed mechanism on your ESAB Welding System: * Clean the liners and mechanical parts of the wire feed mechanism using pressurized air. * Clean and adjust the roller pressure as per the table on the decal on the left side door.
What to do if the thermal protection trips frequently on my ESAB Welding System?
If the thermal protection trips frequently on your ESAB Welding System, ensure that you are not overloading the unit by exceeding its rated data. Also, verify that the ambient temperature is not above 40°C/104°F, as this can cause the thermal protection to activate.
General| Input Voltage | 230 V |
|---|---|
| Input Current | 16 A |
| Wire Diameter | 0.6 - 1.0 mm |
| Protection Class | IP23 |
| Input Frequency | 50/60 Hz |
| Efficiency | 85% |
| Power Factor | 0.7 |
| Insulation Class | F |
To Next Page