Escort iX - Clearing the Database; Serial Number & Software Version; How to Use Preferences

11
Clearing the Database
At some point, you may wish to clear some of the data
in ESCORT iX’s database. This may include any of the
following: Defender Database data, marked locations
or locked-out locations. For details on how to clear
the database, see the Settings & Preferences section.
Serial Number and Software Version
To view your ESCORT iX’s serial number and software
revision, press MRK and MUTE while powering on the
detector.
How To Use Preferences
To access Preferences, press and hold both the MRK
and SEN buttons. ESCORT iX will display “Preferences,”
indicating it is in program mode.
Once the unit is in Preferences mode, the MRK button
is used to review the preference categories, and
the + and − buttons are used to change the individual
settings within the selected option.
To exit Preferences, simply wait a few seconds
without pressing a button. A “Completed” message
will display, conrming your selection(s).
Example:
Here’s how you would turn the Speed Display o:
1 Enter Preferences by pressing and holding both the
MRK and SEN buttons. ESCORT iX will display
“Preferences.”
2 Press the MRK button to scroll through the
categories to “Speed Display.”
3 Since the factory setting is for Speed Display to be
ON, ESCORT iX will show Speed Display as ON.
4 Press the + or − button to change from ON to OFF.
5 To complete this change, simply wait a few seconds
without pressing a button. The unit will display
“Completed” to conrm your selection.
NOTE: You can only access and customize the Speed
Display feature while in the Advanced user mode. See
the Overview of Preferences chart for details on how to
switch user modes.