12
Settings & Preferences – Overview
Press MRK to go from Press + or – to change
one category to the next your setting within a category
User Mode
Advanced* Access and customize all Settings and Preferences
Novice Access and customize units and display color, (all other
Settings are set to factory defaults)
NOTE: Switch to Advance mode to view all Preferences
Pilot Mode Scanning* Scanning Bar with Full Word
Full Word Full Word: Auto, AutoNoX, AutoLoK or Highway
Display Color
Blue* / Green / Red / Amber Set color to match your vehicle’s dash display
Speed Display
On* Displays current speed
Off Displays battery voltage
Cruise Alert
20 mph* Offers double-beep alert tones if traveling below specified speed
Off / 20-160 mph
Over Speed 70 mph* Reminds you when you exceed a specified speed
Off / 20-160 mph
Meter Mode Standard* Single band with bar graph of signal strength
Spec Single band with numeric frequency
Expert Multiple bands with bar graph of signal strengths
Simple Caution (if traveling below Cruise Alert limit)
Slow Down (if traveling above Cruise Alert limit)
Tones
Standard* Standard ESCORT alert tones
Mild Mild doorbell chime alert tones
AutoMute
Low / Med* / High / Off Automatically reduces audio to preferred volume during alert
Press and hold the MRK and SEN buttons to access Preferences. To exit Preferences, simply wait a few
seconds without pressing a button. A
Completed message will display confirming your selection(s).
To Next Page
Loading...
