Escort iX - Installation; Whats Included; Mounting Tips

5
Installation
ESCORT iX comes with our latest EZ Mag Mount™.
Simply tilt the display end of the detector up and slide
it onto the mounting bracket. The magnetic mount
holds the detector in place. To remove the detector
from the mount, simply lift the display end of the
detector and the detector releases from the mount.
What’s Included
•
ESCORT iX Radar/laser detector
• EZ Mag Mount™ windshield mount
• SmartCord USB power adapter
• Quick Reference Guide
• Zippered Travel Case
Mounting Tips
• Place on center of windshield between driver and
passenger.
• Ensure clear view of road ahead and sky above.
• Avoid windshield wipers and heavily tinted areas.
To mount the detector in your vehicle
1 Remove paper backing from EZ Mag Mount™
StickyCup.
2 Ensure the locking clamp is open.
3 Firmly press EZ Mag Mount™ StickyCup onto
windshield and close the locking clamp to secure.
4 To adjust view, loosen thumb wheel and adjust
angle of mounting bracket. Tighten thumb wheel
to secure.
5 Tilt the display end of the detector slightly upward
and engage with the flanged edge of the mounting
bracket. The EZ Mag Mount™ magnet holds the
detector in place.
6 To remove the detector, simply lift the display
end of the detector upward. The ESCORT iX will
release from the mount.
7 To remove mount from windshield, release
locking clamp and pull tab on top of StickyCup.
EZ Mag Mount™ Care Instructions:
Should the EZ Mag Mount™ StickyCup accumulate
debris and lose its stickiness, simply rinse under warm
water, gently wipe off debris and allow to air dry.
Locking Clamp (closed)
Thumb Wheel For
Angle Adjustment
Mounting Bracket
Release Tab
StickyCup
ESCORT iX
EZ Mag Mount™