Programming Menu
MAXcam 360c gives advanced warning of upcoming markers at the following distances:
Red light cameras 250 ft or 10 seconds
Red light & speed cameras 250 ft or 10 seconds
Speed cameras 500 ft when traveling below 55 mph
1,000 ft when traveling above 55 mph
Speed traps 0.3 mi or approximately 1,584 ft
Other 500 ft when traveling below 55 mph
1,000 ft when traveling above 55 mph
To Mark A Location
- Press MRK. The display will read “Mark?” Press MRK again to bring up a menu of markers to
choose from.
- Use the Rotary Dial to scroll through the markers then press MRK to select the marker that you wish
to use at this location.
- The display will read “Marked!”
Air Patrol locations cannot be marked by the user.
Note: When a location is marked the first time, you must travel at least 1 mile away from that location
to receive an alert when you return to the area.
To Unmark A Location
Touch the MRK button when you are receiving a marked-location alert. The display will read
“Unmark?” Touch the MRK button again to confirm. The display will read “Unmarked!”
Clear Locations
At some point, you may wish to clear some of the data in MAXcam 360c’s database. This may include
any of the following: Defender Database data, Marked locations or false alert Lockouts.
To clear locations in the selected database, select the database then press MUTE to confirm.
Format clears locations in all databases.
Wi-Fi
Turns on and off Wi-Fi connection to a hotspot.
20
To Next Page
Loading...
