Programming Menu
AutoPower
This feature automatically turns off MAXcam 360c after a set period of time to save unnecessary drain
on your battery. This is especially useful if your vehicle has a constant-power ignition. To turn
MAXcam 360c on again you must press the power button.
Note: If AutoPower is on, to save screen life the display screen goes blank after 30 minutes without
moving. The display screen will turn on automatically after you reach 10MPH.
Band Enables
In the factory default setting the suggested radar and laser bands for North America are monitored
and sources of some common false alerts are rejected. It is highly recommended that you use your
MAXcam 360c in this mode.
If you modify Band Enables then this setting will show Modified. The MAXcam 360c will also notify you
during the startup sequence with an audible alert.
WARNING: Do not turn off any Band Enables unless you are absolutely certain there are no traffic
radar guns in your area using that specific band.
K Notch
Reduces sensitivity of K band in the frequency range of 24.190 – 24.210 GHz. This is effective at
reducing alerts to certain vehicle collision avoidance systems.
Shifters (only available when optional ZR5 or ZW5 laser shifters are connected)
Sets the shifter mode of operation. Receive = receive-only mode. Shift4/6/8/10 puts the laser shifters
into receive-only mode after 4/6/8/10 seconds from receiving an alert. After 30 seconds of not
receiving a Laser alert, the shifters automatically return to shift mode. You can also manually put the
laser shifters into receive-only mode by double tapping the Mute button on the detector or
SmartCord.
19
To Next Page
Loading...
