24
Radar Menu
GPS Filter
alerts in MAXcam 360c’s memory. Common sources of
door openers and motion sensors. To store a false
alert location, press MUTE three times during an
alert. Subsequent alerts to this signal will be muted
and displayed in grey (factory default is on).
Note that GPS Filter will not lock out moving false
alerts commonly caused by vehicle blind spot
monitoring and collision avoidance systems.
Auto Power
Band Settings
and on Radar bands, K and Ka narrow band
band segments unless you are absolutely certain
band or narrow band in your area.
To navigate Band Settings, select
Modify
, then
repeatedly press MARK to cycle through all of the
a band setting.
To exit Band Settings, select
Exit
or simply wait a
few seconds.
Disabling K band allows you to select K Narrow
segments 1-4.
K Narrow 1 23.950 – 24.050 GHz
K Narrow 2 24.050 – 24.110 GHz
K Narrow 3 24.110 – 24.176 GHz
K Narrow 4 24.176 – 24.250 GHz
Disabling Ka band allows you to select Ka Narrow
segments 1-7.
Ka Narrow 1 33.400 – 33.700 GHz
Ka Narrow 2 33.700 – 33.900 GHz
Ka Narrow 3 33.900 – 34.600 GHz
Ka Narrow 4 34.600 – 34.800 GHz
Ka Narrow 5 34.800 – 35.400 GHz
Ka Narrow 6 35.400 – 35.600 GHz
Ka Narrow 7 35.600 –
36.000 GHz
Location Settings
and on each type of location based alert.
To navigate Location Settings, select Modify, then
repeatedly press MARK to cycle through the
on a location setting.
To exit Location Settings, select Exit or simply wait a
few seconds.
Bluetooth®
default is on).
Wi-Fi
default is on).
Automatically turns off MAXcam 360c after the set
time period. This is especially useful if your vehicle
has a constant-on lighter outlet (factory default is
4 Hours).
To Next Page
Loading...