Programming Menu
Parking Mode
Parking Mode uses the G-Sensor to monitor while your vehicle is parked. The idea is that when you are
parked, the dash cam will be “sleeping”, but it will monitor for G-Sensor impacts. If it detects an impact,
then the unit will wake up and start recording.
The camera will enter parking mode after 5 minutes. If there is no movement during this period, the
display will turn off and the recording will stop. If a G-sensor impact above Level 1 is triggered, the unit
will wake up and start saving 1 minute clips for as long as activity is being detected.
Note: Parking Mode only works properly if the dash cam is powered. Either the Cigarette Lighter Socket
must remain on with the ignition off, or the dash cam must be hardwired to a constant power source
(please check www.escortradar.com for available accessories).
Motion Detect
Motion Detection uses the camera’s Motion Sensor to monitor while your vehicle is parked. The idea is
that when you are parked, the dash cam will be “sleeping”, but it will monitor surroundings for motion. If
it detects motion, then the unit will wake up and start recording.
The camera will enter Motion Detection after 5 minutes. If there is no movement during this period, the
display will turn off and the recording will stop. If movement is detected, the unit will wake up and start
saving 1 minute clips for as long as activity is being detected.
Note: Motion Detection only works properly if the dash cam is powered. Either the Cigarette Lighter
Socket must remain on with the ignition off, or the dash cam must be hardwired to a constant power
source (please check www.escortradar.com for available accessories).
Watermark
Turn off or on placing an Escort watermark on saved video clips (factory default is on).
Date/Time Stamp
Turn off and on placing a date and time stamp on video clips (factory default is on).
Speed Stamp
Turn off and on placing your speed on video clips (factory default is off).
Radar Stamp
Turn off and on placing alert information on video clips (factory default is on).
Format Card
Press MUTE to format the SD card.
Importantly, be aware that this will erase all content on the SD card including locked SOS movie clips.
Once the SD card is full, the camera will continuously overwrite the oldest footage recorded with recent
recordings. To protect a clip so that it will not be overwritten, press the Emergency Record/Favorites
Button so that the clip is moved into the locked content partition.
22
To Next Page
Loading...
