Details of Preferences Options
14 15
Pilot (Power-on indication)
NOTE: When you are using the
Dark mode, the display will only show
ESCORT, REDLINE momentarily.
PilotHWY (Full description)
In this setting, RedLine will display
“Highway,” “Auto,” or “Auto NoX” as its
power-on indication. (factory default)
Pilot H (Letter)
In this setting, RedLine will display “H” for
Highway, “A” for Auto and “ANX” for Auto
NoX.
Pilot H.> (Scanning dot)
In this setting, RedLine will display “H” for
Highway, “A” for Auto and “ANX” for
Auto NoX with a scrolling dot afterwards.
Pilot V (Vehicle voltage)
In this setting, the RedLine will continually
display “H” for Highway, “A” for Auto, and
“ANX” for Auto NoX, plus the vehicle’s
voltage.
NOTE: A high or low voltage
warning is given any time the vehicle’s
voltage goes above 16.5 volts, or drops
below 10.5 volts. This feature is always
on, regardless of the Pilot setting.
Alamp
Alamp On (Alert lamp on)
In this setting, the Alert Lamp will flash on
and off during an alert.
AlampOFF (Alert lamp off)
In this setting, the Alert Lamp will not flash
on and off during an alert.
Power-on Sequence
PwrOnFST (Fast power-on)
In this setting, RedLine will provide a
single X-band tone if the factory default
settings have not been changed.
If any of the factory default band
settings have been disabled, a double X-
band tone and corresponding message (i.e.
“X OFF”), will alert you that one or more
bands have been turned off. (factory
default)
PwrOnSTD (Long)
In this setting, each time you turn RedLine,
it will display “ESCORT”, “ REDLINE,”
“LASER,” “Ka-band,” “K-band,” “X-band,”
followed by a brief X-band alert. (factory
default)
If any of the factory default bands
have been disabled, a double X-band tone
and corresponding message (i.e. “X OFF”),
will alert you that one or more bands have
been turned off.
Signal Strength Meter
MeterSTD (Standard meter)
In this setting, the meter displays the band
of the received signal, and a bar-graph will
show the relative signal strength. (factory
default)
MeterEXP (ExpertMeter)
In this setting, the meter will
simultaneously track multiple radar
signals, including relative signal strength
for each.
NOTE: ExpertMeter is explained
in more detail on pages 10-11.
MeterSPC (SpecDisplay meter)
In this setting, the meter displays the
actual numeric frequency of the radar
signal received.
NOTE: The Spec Display feature is
explained in more detail on page 11.
Brightness
BrtAuto (Factory default)
In this setting, the brightness for the display
is controlled automatically by a sensor that
measures the ambient light in the vehicle.
Sunlight will increase the brightness level,
while dim or no light (night driving) will
decrease the brightness.
BrtMin
In this setting, the display is set to a
minimum light level. This setting is retained
in memory even if the power is turned off.
BrtMed
In this setting, the display is set to a
medium light level. This setting is retained
in memory even if the power is turned off.
BrtMax
In this setting, the display is set to a
maximum light level. This setting is retained
in memory even if the power is turned off.
BrtDark
In this setting, the display will be totally
dark. The supplied SmartPlug will provide
the only visual indication that the RedLine
is operational.
To Next Page
Loading...
