ESD CAN-USB/2 - CAN Interface; Software Support

Technical Data
4.3 CAN Interface
Number of CAN
interfaces
1
CAN protocol ISO 11898-1 (11 and 29 bit CAN identifier are supported)
Physical Layer
high-speed CAN interface according to ISO 11898-2, transmission rate
programmable from 10 Kbit/s to 1 Mbit/s
Bus termination terminating resistor has to be set externally, if required
Electrical isolation
of CAN-interfaces
from other units
via digital isolators and DC/DC-converters
Table 4: Data of the CAN interface
4.4 Software Support
Device drivers for Windows
®
and Linux
®
are available. Drivers for other operating systems,
especially real-time operating systems, are available on request.
CAN-USB/2
Hardware Manual • Doc. No.: C.2066.21 / Rev. 1.6
Page 13 of 28