Safety Instructions
● When working with the CAN-USB/2 follow the instructions below and read the manual carefully to
protect yourself from injury and the CAN-USB/2 from damage.
● Do not use damaged or defective cables to connect the CAN-USB/2 and follow the CAN wiring hints
in chapter: "Correct Wiring of Electrically Isolated CAN Networks".
● In case of damages to the device, which might affect safety, appropriate and immediate measures
must be taken, that exclude an endangerment of persons and domestic animals and property.
● Current circuits which are connected to the device have to be sufficiently protected against
hazardous voltage (SELV according to EN 60950-1).
● The CAN-USB/2 may only be driven by power supply current circuits, that are contact protected.
A power supply, that provides a safety extra-low voltage (SELV) according to EN 60950-1, complies
with this conditions.
● Do not open the housing of the CAN-USB/2.
● The CAN-USB/2 has to be securely installed before commissioning.
●
Never let liquids get inside the CAN-USB/2. Otherwise, electric shocks or short circuits may result.
● Protect the CAN-USB/2 from dust, moisture and steam.
● Protect the CAN-USB/2 from shocks and vibrations.
● The CAN-USB/2 may become warm during normal use. Always allow adequate ventilation around
the CAN-USB/2 and use care when handling.
● Do not operate the CAN-USB/2 adjacent to heat sources and do not expose it to unnecessary
thermal radiation. Ensure an ambient temperature as specified in the technical data.
Qualified Personnel
This documentation is directed exclusively towards personnel qualified in control and automation
engineering. The installation and commissioning of the product may only be carried out by qualified
personnel, which is authorized to put devices, systems and electric circuits into operation according to the
applicable national standards of safety engineering.
Conformity
The CAN-USB/2 is an industrial product and meets the demands of the EU regulations and EMC standards
printed in the conformity declaration at the end of this manual.
Warning: In a residential, commercial or light industrial environment the CAN-USB/2 may cause radio
interferences in which case the user may be required to take adequate measures.
Intended Use
The intended use of the CAN-USB/2 is the operation as an USB 2.0-CAN-Interface
The guarantee given by esd does not cover damages which result from improper use, usage not in
accordance with regulations or disregard of safety instructions and warnings.
●
The CAN-USB/2 module is designed for indoor operation only.
● The operation of the CAN-USB/2 in hazardous areas, or areas exposed to potentially explosive materials is
not permitted.
● The operation of the CAN-USB/2 for medical purposes is prohibited.
Service Note
The CAN-USB/2 does not contain any parts that require maintenance by the user. The CAN-USB/2 does not
require any manual configuration of the hardware. Unauthorized intervention in the device voids warranty
claims.
Disposal
Devices which have become defective in the long run have to be disposed in an appropriate way or have to
be returned to the manufacturer for proper disposal. Please, make a contribution to environmental protection.
CAN-USB/2
Hardware Manual • Doc. No.: C.2066.21 / Rev. 1.6
Page 5 of 28
To Next Page
Loading...