Esko Kongsberg XN IPC 2.0 User Manual

Kongsberg XN / iPC 2.0
iv
10.12.1 Vacuum Section Configuration......................................................................................... 53
10.12.2 Using two vacuum pumps................................................................................................ 55
10.13 Router Setup.................................................................................................................................55
10.14 Conveyor Belt Control................................................................................................................. 55
10.14.1 Split Sheet Feed................................................................................................................. 56
10.14.2 Sheet Feed Correction.......................................................................................................56
10.15 Board Size.....................................................................................................................................56
11. Tool Configuration and Adjustment.................................................................................................. 57
11.1 Introduction.................................................................................................................................... 57
11.2 Adjust Active Tool...........................................................................................................................57
11.3 Tool Height Calibration..................................................................................................................58
11.4 Lag Settings (for Rotating Tools)...................................................................................................58
11.5 Rotation Adjustment (for Rotating tools).....................................................................................60
11.6 Center Offset Adjustment............................................................................................................. 61
11.7 Manual adjustment of Center Offset and angle......................................................................... 62
11.8 Tool Offset...................................................................................................................................... 62
11.9 Maintain Tool List (More...)............................................................................................................63
12. Tooling System....................................................................................................................................... 65
12.1 Tool handling and care..................................................................................................................65
12.2 Tool Inserts with built-in motor....................................................................................................65
12.3 Tool Heads available, overview.....................................................................................................66
12.4 Tool Head mount / dismount........................................................................................................67
12.5 FlexiHead.........................................................................................................................................67
12.6 PowerHead......................................................................................................................................69
12.6.1 ø150 mm Crease Wheel......................................................................................................70
12.6.2 Crease Adapter ø26 mm.....................................................................................................70
12.6.3 Perforation Wheel ø60 mm................................................................................................ 71
12.6.4 HD Knife Tool....................................................................................................................... 73
12.6.5 V-notch Knife........................................................................................................................73
12.7 FoamHead.......................................................................................................................................78
12.8 MultiCUT-HP....................................................................................................................................80
12.8.1 Introduction..........................................................................................................................81
12.8.2 Tool Head description......................................................................................................... 82
12.8.3 Safety Issues.........................................................................................................................86
12.8.4 Precautions...........................................................................................................................88
12.8.5 Routing Advice..................................................................................................................... 91
12.8.6 Cleaner Device..................................................................................................................... 94
12.8.7 Bits and Bit Change.............................................................................................................94
12.8.8 Chuck Change and Cleaning...............................................................................................96
12.8.9 Bit Slipping, Chuck Change............................................................................................... 100
12.8.10 Bit Length and Position...................................................................................................100
12.8.11 False Air valve.................................................................................................................. 101

Esko Kongsberg XN IPC 2.0 Specifications

General

Brand	Esko
Model	Kongsberg XN IPC 2.0
Category	Cutter
Language	English