Need help?Do you have a question about the ESPEC 17MB95S and is the answer not in the manual?
Integrates a complete hybrid TV tuner supporting worldwide terrestrial and cable TV standards.
A 10-W/15-W, efficient, digital audio-power amplifier for driving stereo bridge-tied speakers.
A differential Class-D BTL power amplifier, able to drive up to 2.3W into a 4 load.
Headphone is a SoC (single on chip) configuration in mainboard.
1,073,741,824-bit CMOS Double Data Rate III (DDR3) Synchronous DRAM.
DDR3 SDRAM with high speed double-data-rate transfer rates up to 1866Mb/sec/pin.
2Gbit NAND Flash Memory with 2048 blocks, x8 interface.
CMOS 16,777,216 bit serial Flash EEPROM with SPI interface.
Low-power, configurable, MTT hub controller IC products for embedded USB solutions.
Procedure for updating the main software for the MB95 project.
TV is working but has no picture and backlight.
CI is not working when CI module is inserted.
TV stays in standby mode and no other operation.
LED or IR not working.
Keypad or Touchpad is not working.
USB is not working or no USB Detection.
No audio at main TV speaker outputs.
Device can not boot, TV hangs in standby mode.
No signal in TV mode.
To Next Page
General