Use a grounded three-wire extension cord and
receptacle for all machines with electric start
engines.
Check clutch and brake operation frequently.
Adjust and service as required. All motion of drive
wheels and auger must stop quickly when control
levers are released.
Let engine and machine adjust to outdoor
temperature before starting to clear snow.
Stay alert for hidden hazards or traffic.
Do not overload machine capacity by attempting
to clear snow at too fast of a rate.
Do not throw snow any higher than necessary.
Adjust auger housing height to clear gravel or
crushed rock surfaces. Exercise extreme caution
when operating.
Exercise caution to avoid slipping or falling,
especially when operating in reverse. Never
operate machine at high transport speeds on
slippery surfaces. Always look down and behind
before and while backing.
Do not operate on steep slopes. Do not clear
snow across the face of slopes. Keep all
movement on slopes slow and gradual. Do not
make sudden changes in speed or direction. Use
a slow speed to avoid stops or shifts on slopes.
Avoid starting or stopping on a slope. Do not park
machine on a slope unless absolutely necessary.
When parking on a slope, always block the
wheels.
Disengage power to the auger when transporting
or not in use.
Disengage all control levers and stop engine
before you leave the operating position (behind
the handles). Wait until the auger comes to a
complete stop before unclogging the chute
assembly, making any adjustments, or
inspections.
Hand contact with the rotating parts inside the
discharge chute is the most common cause of
injury associated with snow throwers. Do not
unclog chute assembly while engine is running.
Shut off engine and remain behind handles until
all moving parts have stopped before unclogging.
Never put your hand in the discharge or collector
openings. Always use the clean-out tool provided
to unclog the discharge opening.
To Next Page
Loading...