15. Hold the trigger cap down and rotate the
joystick in a circle to ensure the that the
discharge chute and chute deflector operate
smoothly.
16. Install and secure the gear cover.
Speed Shift Linkage
Note: In some models the shift arm has already
been installed on shift yoke at the factory.
1. Place the shift arm on shift yoke. Line up the
holes in the shift arm and shift yoke. Insert a
roll pin through the holes.
2. After the shift rod with a flat washer has been
inserted through the hole in the shift arm, add
the other flat washer on the shift rod, and
secure with a clevis pin.
3. Lift up on the shift rod. Loose the jam nut
under the trunnion and thread the trunnion
along the shift rod until it fits into the hole in
the shift lever. Tighten the jam nut and Install
washer and M8 nut. Tighten securely.
Replacement Shear Pins
A pair of replacement auger shear pins and clevis
pins are included with your snow thrower. Store
them in a safe place until needed.
To Next Page
Loading...