3. The equipment must be operated only by, or under the direct supervision of a properly trained and
qualified person.
4. Modifications to this equipment may only be carried out by the manufacturer's service technicians or
other authorized persons.
5. Customer maintenance of this equipment may only be performed as stated in the user's manual and
service manual. Any additional maintenance may only be performed by the manufacturer's service
technicians or other authorized persons.
6. The manufacturer is only responsible for any effects on safety, reliability, and performance of this
equipment on condition that the following requirements have been fulfilled:
(1) the electrical installation in the respective room is consistent with the specifications stated in this
manual and,
(2) this equipment is used, operated, and maintained according to the instructions given in this
manual and the service manual.
7. The manufacturer is not liable for damage caused by unauthorized tampering with the device(s). Such
tampering will forfeit any rights to claim under warranty.
8. Interconnected equipment to this equipment shall be complied with the applicable international
standards, e.g. IEC/EN 60950-1 for I.T equipment.
9. Only persons who have undergone proper training and instructions are authorized to install, use,
operate, and maintain this equipment.
10.Keep the user's and service manuals in a place that can be accessed any time by the persons
operating and maintaining the equipment.
11.Do not force cable connections. If a cable does not connect easily, be sure that the connector (plug) is
appropriate for the receptacle (socket). If you cause any damage to a cable connector(s) or
receptacle(s), the damage must be repaired by an authorized service technician.
12.Please do not pull on any of the cables. Always hold on to the plug when disconnecting cables.
13.This equipment may be used for the international application.
14.Before every operation, visually check the equipment for exterior mechanical damage and to ensure
that it is operating properly.
15.Do not cover any of ventilation grids or slits.
16.Immediately turn OFF and unplug any equipment that gives off smoke, sparks, strange noises or
odours.
17.Use only accessories (including power supply) provided by the manufacturer.
18.No contraindication.
To Next Page
Loading...
Need help?
General