14 DUSTOMAT 21-67 H 09302-52-00
The quarter-inch compressed air connection nozzle is on
the upper filter housing.
The compressed air supply line (4-6 bar, oil- and water-free)
can be connected to the device with a model DN 7.2 ¼-inch
coupling.
After connecting the suction hose to the processing machine, first set the
dust extractor in motion, and then the processing machine. When switching
off, follow the same procedure in reverse.
During operation, the dust extractor’s location should not be changed.
When the device is turned off, the neutral line is not disengaged. The device
is therefore intended only for use in TN networks.
8. Maintenance and troubleshooting
8.1 Maintenance instructions
For maintenance by qualified personnel, the device must be opened, cleaned and
inspected at the given locations, as far as this is feasible, without any hazard
being posed to maintenance personnel or to other persons. Proper precautions
must be taken before cleaning and removal of wearing parts. This includes locally
filtered forced-air ventilation in the area in which the device is being maintained
and proper personal protective gear.
During maintenance or repair work, all soiled objects that can no longer be
adequately cleaned must be disposed of. Such objects must be discarded in an
impermeable bag in compliance with applicable regulations for disposal of such
refuse.
If the device is not needed in its location of use for a long time, it must be stored in
a dry room. The temperature should not be below 5°C or above 25 °C.
Before the device is placed into storage, it is recommended that it be cleaned with
a disposable damp cloth, that the filter be cleaned, and that the dust container be
emptied.
The device must never be cleaned with flowing water.
To Next Page
Loading...
