09302-52-00 DUSTOMAT 21-67 H 25
Since the ESTA company does not know what types of dust are being
exhausted, it can be necessary to replace the dust collection bag before it
has reached its maximum fill level (a large bulk density means heavy
weight).
Before replacing the dust collection bag, lock the castors, raise the locating pin on
the intake connection piece, and pull off the suction hose. To remove the full dust
collection bag, after opening the buckle closure, tilt the upper part of the device in
the direction of the fan.
To remove the dust collection bag, pull this carefully upward and press it together
about 30 cm below the upper edge of the bag. Tighten this 30 cm to about 15 cm
at the upper edge, close it with the band included, remove it from the container,
and dispose of it in accordance with local regulations.
When inserting a new dust collection bag, make sure that it lies flat against the
walls of the container and overlaps the upper edge as little as possible. Turn the
device off again, snap the upper part of the device shut, and close the buckle
closure. Turn the device back on. It should remain on until the dust collection bag
is lying completely against the wall of the container. This process takes about 1
minute. Make sure that the upper part of the dust collection bag does not form a
collar that can collect dust. Insert the suction hose and lock it. The device is now
ready to operate again.
Follow applicable regulations when disposing of the collected material!
11.2 Disposing of the dust extractor
Before disposing of the device, empty the dust collection container, remove the
filter cartridges, and dispose of both of them in compliance with local regulations.
Pack the device in a suitable manner and dispose of it in compliance with local
regulations.
Due to contamination of the device with toxic dust, ESTA cannot take the device
back.
To Next Page
Loading...
