09302-52-00 DUSTOMAT 21-67 H 5
Make sure that the power cable does not become damaged by being run over,
compressed, pulled, etc.
The power cable must be examined regularly for signs of damage or ageing.
The device must not be used if damage to the power cable is detected.
The power cable and plug must be replaced only by an appropriately trained
electrical specialist.
For the power supply and the device’s power cords, only original ESTA
replacement parts must be used. This guarantees that they are spray-proof
according to applicable standards and have the necessary mechanical strength.
The power cord must be plugged in only after the dust extractor has been
successfully set up at its place of use. For this a 16-amp CEE wall socket must be
in place.
Plugs and connectors complying with EN 61241-14 must be used for connecting
electrically driven industrial dust extractors and dust extractors. Coupling plugs
and connectors or adapters are not permitted.
After use, before moving the device to another site and before cleaning,
maintenance, or the replacement or removal of movable parts, the device must be
unplugged and any compressed air must be disconnected.
The DUSTOMAT is to be moved on a stable, even surface that can securely
support a weight of 350 kg.
To prevent dust release when transporting the device, the intake connection piece
must be closed with the sealing plug.
Only original ESTA conductive accessories may be used for operating the
device.
From its first use, the device contains toxic dust. Emptying and
maintenance processes, including removal of the dust collection container,
must be performed by expert personnel who are wearing appropriate
protective gear. The device must not be operated without the complete
filtration system!
To Next Page
Loading...
