– When the appliance is in operation, prevent pets, plants or insects to get in contact with it.
– Do not plug the power cord in the electrical socket and do not unplug it with wet
hands or by pulling the power cord!
– The appliance is intended for home use and for similar purposes (in shops, offices and
similar sites, in hotels, motels and other residential premises, or in facilities providing bed
and breakfast service). It is not intended for commercial use!
– Watch the appliance for the entire time of food processing!
– Do not place any objects on the top of the appliance.
– Only use the appliance in the working position at places with no risk of overturning and in
a sufficient distance from other objects (such as curtains, drapes, etc.), heat sources
(e.g. fireplace, heater, stove, cooker, radiators, hot air ovens, grills) and wet surfaces
(e. g. sinks, wash basins).
– This appliance is not intended for outdoor use.
– The appliance must not be used in a damp or wet environment and in any environment
with the danger of fire or explosion (premises where chemicals, fuels, oils, gases,
paints and other flammable or volatile materials are stored).
– Never immerse the drive unit (or any part of it) in water!
– It is not allowed to modify the surface of the appliance in any way (e.g. using
a selfadhesive wallpaper, foils, etc.)!
– Before preparation, remove possible packages from food (e.g. paper, a PE bag, etc.).
– If the appliance was stored at a low temperature, acclimatise it first
– Do not turn on the appliance without any ingredients inside!
– Always use only one function of the appliance, never turn on several functions at the same
time (e.g. processing food in the bowl B1 and at the same time in the blender F).
– Do not exceed the maximum time of uninterrupted operation – see the table. Never exceed
the total time of 30 minutes of uninterrupted operation. Then let the food processor cool
down for at least 30 minutes.
– Before connecting the appliance to the mains, make sure it is turned off.
– Do not use safety lock controlled by the blender cover A9 for switching off the appliance!
– Your foot processor is fitted with an electronic speed sensor control that is designed to
maintain the speed under different load conditions. You may therefore hear some variation
in speed during the operation as the foot processor adjusts to the load and speed selected
- this is normal.
– The appliance is equipped with thermal safety fuse which disconnects current supply incase
of engine overloading. If it occurs, unplug the appliance and let the appliance getcooled.
– For safety reasons, it is not possible to exchange the attachments while the drive unit is in
operation.
– The container is not intended for storage of foods. After the foods are processed, put them
in another container fit for storage.
– If the processed foods stick to the accessories (e.g. whisks, kneading hooks, blender
blades, exchangeable discs), lid or container, turn off the appliance and clean the
accessories carefully with a spatula.
– Do not insert accessories into any body cavities.
–
When assembling accessories, carefully follow the instructions for use. Any other assembly
combinations are not permissible, otherwise the appliance shall not properly work!
– Never assemble accessories on the top of the drive unit (outside accessorie J)!
– Before removing accessories from the drive unit, allow the rotating parts to stop completely.
– When mounting or removing the bowl, do not apply much pressure on the bowl handle.
– Do not lift and carry the food processor using the bowl handle, but always use the
recesses at the bottom of the drive unit!
75
GB
To Next Page
Loading...