26
9 Settings legrests
For outdoor use the
footrests should be
raised 4-5 cm above the
ground. Never stand on
the footrests as there is
a risk of tipping!
Make sure the screw-
head locks in the
hexagon hole.
Right Left
A
B
9:6 Height of the footrests
Cross is supplied with flip-up foot-
rests, adjustable in height, setta-
ble in angle and depth.
Height
Loosen the locking
handle (A) on the legrest fully.
Remove the screw (B).
Set the height. Replace the screw
and handle. Tighten securely.
(!) - To make the footrests higher
than standard there are also
short/narrow legrests with
footrests with 8 cm shorter
attachment tubes.
- To make the footrests lower
than standard there are foot-
rests with 10 cm
longer attachment tubes.
The footrests can also be adjusted
in angle and depth.
Angle: Loosen the screws (C)
slightly. Adjust to the required
position and tighten again.
Tools: 5 mm Allen key.
Depth:
The sides of the footrests have
different lengths. By changing
the left side for the right they will
extend further forwards.
C
9:7 Angle and depth of the footrests
(!) If the depth is altered, the
angle must be adjusted.
To Next Page
Loading...
