Why does my Etac Prio pull to the side?
If your Etac Wheelchair pulls to the side, ensure the front fork attachments and rear wheels are correctly mounted. Also, check if the user is distributing their weight evenly in the wheelchair, and that equal strength is being used on both sides.
Why is my Etac Wheelchair heavy to operate?
To address a heavy feeling when operating your Etac Wheelchair, start by verifying that the rear wheels are properly mounted. Additionally, clean the castor axles of any accumulated hair and dirt. If the issue persists, it might be due to excessive weight over the castors; in this case, adjust the center of balance.
Why is my Etac Wheelchair heavy to turn?
If your Etac Wheelchair is hard to turn, first check that the front forks haven't been tightened too much. Also, clean the castor axles to remove any hair or dirt. If it's still difficult, the issue might be too much weight over the castors, so try adjusting the center of balance.
What to do if electrical back and seat recline function does not work on Etac Wheelchair?
If the electrical back and seat recline function of your Etac Wheelchair isn't working, check the following: * Ensure the hand control is activated by pressing the on/off button. * If at the end position, use the opposite button. * Charge the battery if it's low. * Unlock the hand control function. * Verify the hand control is correctly connected to the electronics unit. If these steps don't resolve the issue, the hand control, electronic unit, or cables may be damaged, and you should contact your retailer or a technician for replacement.
How to fix the attendant brake on Etac Prio if it is not effective?
If the attendant brake on your Etac Wheelchair is not effective, adjust the wire length using the adjustment nipple on the brake drum.
Why do the castor wheels wobble on my Etac Prio?
If the castor wheels on your Etac Wheelchair wobble, make sure the front forks are tightened sufficiently and that the front fork attachments are mounted correctly. If the problem persists, it might be due to too much weight over the castors; try adjusting the center of balance.
How to adjust user brake on Etac Wheelchair?
If the user brake on your Etac Wheelchair is not effective, adjust the distance between the tire and the brake.
What to do if electrical back and seat recline function does not work in spite of action taken on Etac Prio?
If the electrical back and seat recline function of your Etac Wheelchair still doesn't work after taking action, reset the system by pressing and holding the arrow up buttons for five seconds.
How to fix rear wheels if they are loose on Etac Prio?
If the rear wheels of your Etac Wheelchair feel loose, adjust the length of the axle shaft.
Why are the rear wheels hard to remove/replace on Etac Prio?
If the rear wheels of your Etac Wheelchair are hard to remove or replace, clean and lubricate the quick release mechanism using cycle oil, for example. If this doesn't solve the problem, adjust the length of the axle shaft.
Describes the purpose and target users of the wheelchair.
Details the process for charging the battery and understanding indicators.
Covers seat height adjustment using rear wheel, front fork, and attendant brake.
Covers front/rear seat depth and back height adjustments.
Explains manual symbols, warnings, and general safety precautions.
Covers vehicle transport, stairs, air transport, cleaning, and fault-finding.
Covers brake adjustment, lever adjustment, and adapter mounting procedures.
General| Brand | Etac |
|---|---|
| Model | Prio |
| Category | Wheelchair |
| Language | English |
To Next Page
