± 2,5 cm
5 mm
7. Settings
During installation, make sure that the hubs end up
in the same position on the right and left side.
During installation, check that the rear wheel is
securely mounted. The button in the hub should
pop out to the original position.
See also section ”Seat height table”.
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
Seat height adjustment using the rear wheel position
The chassis undercarriage must always be horizontal. When
adjusting the seat height, it is therefore also necessary to adjust
the castor wheel position in the fork or change the castor/fork (see
Section ”Seat height table).
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
Height adjustment, front
Height adjustment, front, using the castor wheel position in the fork
To Next Page
Loading...
