Etac Prio - 7. Settings and Adjustments; Seat Height Adjustment Methods

14
Etac / Prio / www.etac.com
14 Nm
17 mm
24 mm
20”, 22”, 24”
16”
1 2a
2b
!
16”
7. Settings
Seat height
Seat height adjustable using:
- The rear wheel position in the gable and
the castor position in the fork.
- Change of rear wheel size
The chassis undercarriage must always be horizontal.
When changing the seat height, the front seat
height must also be adjusted. See Section
"Height adjustment, front".
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
Seat height adjustment using the rear wheel position
1. Loosen the nut.
2. Open the kit with the washers and install at the required position
(see table in Section ”Seat height table”).
An adaptor sleeve should be used with 16" wheels in positions A2
and B2.
3. Adjust the castors/castor fork so that the chassis
undercarriage is horizontal (see section
”Height adjustment, front”).
4. Adjust the user brake, see section ”Brake, adjustment”.
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
In certain rear wheel positions, there is a crushing
hazard between the arm support and rear wheel (if
the arm support is set at low height).