Page 16 of 20 BM15101 Molift NOMAD English - Rev. M 23-08-2013
Maintenance
Cleaning
Detergents must be pH-neutral. Do not use
solvents or strong liquids - this may damage
surfaces on the lifter. For disinfection when
needed; use isopropyl alcohol. Avoid abrasive
cleaning products.
Clean surfaces with a damp cloth using an appro-
priate detergent.
Regular cleaning is recommended and should be
implemented in the suitable cleaning routines.
Monthly maintenance
• Run the lifter through the complete installation,
and check that it is running smoothly.
• Verify that the hand control contact is rmly
in place. Clean contact and hand control with
white spirit to remove grease and dirt.
• Check that the hand control cable has no dam-
age.
• Check that the lifting belt has no damage, re-
move hair, dirt and dust from opening and
check that the belt moves out and in easily
throughout the length of the belt.
• Run lifter up and down to verify that it moves
normally without any abnormal noise.
• Check that the battery and service light gives
no signal. Contact local service representative/
dealer or Etac Supply Gjøvik if the lifter does
not work properly or if the service light illumi-
nates.
Periodic inspection
Molift recommends periodic inspection of the
lifter once a year according to checklist on page
18. Periodic inspection is to be performed by au-
thorized personnel. The rail system has a separate
checklist for annually inspection.
One checklist is to be lled in and signed for each
lifter after inspection. The owner of the lifter is re-
sponsible for keeping the list for information.
Troubleshooting
If you are not able to solve the fault or problems by
yourself using this manual, please contact your lo-
cal authorized service representative. If you don’t
know whom to contact locally, please contact your
dealer or Etac Supply Gjøvik to get help.
Symptom Possible cause/action
The lifter does
not work
Battery discharged / charge
battery
Emergency stop is activated
(pushed in) / turn clockwise to
reset
The cable/contact of the hand
control has disconnected / re-
connect contact
Hand control has failed / use
operating buttons on lifter,
switch hand control or contact
local service representative
for service
Lifting belt is untight / tighten
lifting belt, raise lifter
Defective control electronics
/ contact local service repre-
sentative for service
Lifter is defective / contact lo-
cal service representative for
service
Lifter moves
slowly or makes
noise
Brakes defective / contact lo-
cal service representative for
service
The lifter is not
charging
Emergency stop is activated /
Reset emergency stop
Plug for charger is not con-
nected to power (no light on
charging light) / Connect to
power outlet
Hand control not placed cor-
rect in charger / Check that
the hand control is placed
correct in the charger.
Connection between charg-
er and hand control, or hand
control and lifter, is bad /
Check and clean the con-
tact points on the charger and
hand control.
To Next Page
Loading...
