Page 7 of 20
Assembly/disassembly
To be able to operate the Molift NOMAD, the oper-
ator must have good knowledge of the lift, includ-
ing assembly and preparation before use.
Assembly
The lifter shall only be mounted on a rail sys-
tem with a capacity on 255 kg or higher.
If the Molift NOMAD is mounted on a rail sys-
tem with a lower lifting capacity, the lowest
capacity also applies for the lifter.
Etac Supply Gjøvik has the system liabili-
ty only when the rail system with trolley is
mounted by authorized service representa-
tive/dealer or Etac Supply Gjøvik.
Take care that the lifter do not get damaged
by hitting the floor or walls. Danger of person-
al injury if the lifting hooks are damaged.
• Attach the safety hook on the lifting belt on the
attachment arm.
• Hook the attachment arm to the trolley. The
arm will swing up when the lifter is hanging in
the hook.
• Alternatively, the lifting belt can be hooked di-
rectly onto the trolley.
• Connect the hand control unit to the lifter.
• Reset the emergency stop button.
Checklist after mounting
• Check that the lifter has no visible damage or
missing parts.
• Check that the batteries are suciently
charged.
• Make sure that the lifter is properly attached to
the trolley and attachment arm, and that the
safety hook is locked.
• Check that the lifter functions correctly by run-
ning it up and down.
If any damage or faults occur on the lifter or
the rail system, contact your local service rep-
resentative/dealer or Etac Supply Gjøvik im-
mediately. The lifter shall not to be used.
Disassembly
• Lower the lifter enough to hold it.
• Untighten the lifting belt and remove it from
the trolley using the attachment arm, or release
the safety hook.
• The lifter can be moved.
The control electronic has a power saving fea-
ture, which puts the system into stand by af-
ter a while of no activity. Activate one button
and the service lamp will give a green light to
show that the lifter is ready for use.
Storage and transportation
- Storage: For long time storage it is
recommended that the battery is removed and
the emergency stop button is activated. The
lifter can be stored and transported under the
following conditions:
• Pressure: 70 - 106 kPa
• Humidity: 15 - 93 %
• Temperature: -25 - 70 °C
- The lifter is designed for use at standard room
temperatures (+5 to +40°C). Following storage
or transport at other temperatures leave the
lifter in a room with a suitable temperature
until it reaches a safe operating temperature.
Trolley
Attachment arm
Lifting belt
Lifter
To Next Page
Loading...
