Page 17 of 20
Service
On the front right side of the lifter there is a service
light which will give a signal when the lifter needs
service. When there is a green light, the lifter can
be used normally. If there is no light, push one of
the up/down buttons to activate the electronics,
and the service lamp will illuminate.
The electronics measures the operating time of
the lifter, and after a specic time the yellow light
will illuminate, indicating that the lifter needs serv-
ice. Take contact with your local Molift service rep-
resentative/dealer. The lifter can still be operated,
but after a while an audible alarm will sound, to re-
mind the operator that the lifter needs service im-
mediately.
Service light codes
Service light Mode
No light Power saving
Green Ready for use
Yellow Book service
Red Perform service
Red + sound Perform service imme-
diately
Flashing yellow Overheating
Service is done according to procedures in the
technical manual for the lifter.
Spare parts
A list of spare parts is avalable on request.
Service light
Battery light
Labelling
Explanation of the lifters labelling:
Part number Serial number
Controlled
and approved
Type BF applied part
CE certied
Refer to user manual
Electrical Emergency lowering
255 560
Max user weight 255 kg
CSA certied
Do not dispose in general waste
To Next Page
Loading...
