ETC Quick Guide
ColorSource Relay and ColorSource Transmitter
Relay and Wireless DMX Transmitter Page 4 of 5 ETC
RDM
Remote Device Management (RDM) allows for remote configuration of
several device properties, and allows you to view several read-only properties:
• RDM Device Count
•Type Description
• Product Details List
• Manufacturer
• Defaults
• Software Version
• Sensors List and Values
• Output Power (Instantaneous Voltage and Current w/ min/max record)
Any RDM controller, such as Net3 Concert or Eos Family software, can be
used to configure these options (default values are in bold):
• Name - ColorSource Relay
• RDM Enable - 01 = enable, 00 = disable (enable/disable RDM Traffic on
the Wireless Bridge's DMX output)
• DMX Address - 1-512
• Threshold - 1-99%, default is 50%
• DMX Loss Time - 1-30 minutes, default is 5 minutes
• Max Turn On Delay - 0-30 seconds, default is 2 seconds
• Relay Personality/ Mode - 01 = Auto Mode, 02 = DMX Mode, 03 =
RDM Mode
• Wireless ID - editable if ID is set to C on UI, 1=201, 2=102, 3=117,
4=133, 5=149, 6=165
• Identify - 01 = blink all LEDs, 00 = deactivate, 1 min timeout
To Next Page
Loading...
