62 Hog 4 Operations Manual
To assign a static IP address:
1. Main → Network → Console → Conso le L ink Co nfig : navigate to the IP Config
screen.
2. Set DHCP Off.
3. Set the IP Address and Subnet Mask as required.
4. OK : return to the Console Link Status screen.
5. Close : return to the Network Configuration screen.
6. OK : return to the Main screen.
3.2.4 Setting the DMX Processor DMX Output Refresh Rate
You can use set the DMX Processor's DMX output refresh rate from 2HZ to 42HZ. The
default DMX refresh rate for a new show is 25HZ.
To set the DMX refresh rate of a DMX Processor locally using the on-board LCD panel:
1. Select DMX from the main menu.
2. Use the front panel buttons to set the desired DMX refresh rate.
To set the DMX refresh rate of a DMX Processor using the Console:
1. Setu p → Ne twork on the Setup Toolbar. Select the required DMX Processor in the
network window and click Settings.
2. Select the DMX tab of the DMX processor settings window.
3. Enter the desired DMX refresh rate in the DMX refresh rate field and press apply.
NOTE: In order to achieve rates above 29Hz users must first set the inter-slot time of the
processor to 0 microseconds. For refresh rates below 29Hz users can choose to use either
0ms or 20ms as the inter-slot time.
3.2.5 Setting the DMX Processor back to Defaults
In the Control Panel screen you can set the DP back to it's factory default settings:
Main → Con trol Pane l Set to Defaults.
3.2.6 Locking the DMX Processor Front Panel Controls
You can use the Lock function to lock the DMX Processor's controls. The default PIN is
1234; a new PIN can be assigned from a Hog console via Setup → Netwo rk on the Setu p
Toolbar . Select the required processor in the network window and click Settings. Change
PIN and O K to apply and close the window.
To lock the DMX Processor locally:
In the Control Pan el, select Lock : the Enter PIN to Unlock screen will appear.
To unlock the DMX Processor locally:
Enter your chosen 4-digit code number, and cursor right to confirm. The code number
will be the default 1234 if you have not changed it to your own.
To Next Page
Loading...
