2 CEM+ Sensor Rack Retrofit Manual
Safety
Please note the following safety warnings before use:
• Disconnect power from the rack(s) before all maintenance.
Overview of this Manual
Reference this manual throughout the retrofit procedure.
• Preparation, page 5 - before you open the rack.
• Remove the Old, page 5 - labeling and remove the existing equipment.
• Control Input Panel Replacement, page 6 - remove the existing control input panel from
the rear of the rack and install the new one.
• Power Termination, page 8 - install and secure the power harness adapter cable.
• Data Cabling Preparation, page 8 - install and secure the dimmer data transition
boards.
• Install the New Backplane & Make Connections, page 9 - install the new backplane and
connect and secure the data cabling.
• Change out the AF Cards (if present)), page 11 - remove the existing Advanced
Feature cards and install the new ones.
• Finish Up, page 11 - reinstall the left side of the rack.
• Verify the Retrofit, page 12 - put the dimmers back in the rack and power up the rack.
• Configure the CEM+, page 12 - put a configuration in the CEM+.
When viewing this document in electronic form (pdf file) with Adobe Acrobat Reader, blue
italicized text followed by a page number such as “Overview of this Manual, page 2” is a
link within the document. If you click on the link, it will jump to that section or topic.
WARNING:
RISK OF ELECTRIC SHOCK! Dimmer racks without an accessible power
disconnect device cannot be serviced safely.
To Next Page
Loading...
