-12-
measurements.
3. Examples Illustrated
⑴. ---Jaw is in open state, and cannot
measure
⑵. ---Boot error instructions Er (Error)
⑶. ---Measured loop resistance is less
than 0.01Ω
⑷. ---Measured loop resistance is 5.1Ω
⑸. ---Measured loop resistance is 2.1Ω
---Lock the current measurement
value: 2.1Ω
---Auto storage as 08 set data
⑹. ---Access to the stored data of Unit No.26
---Measured loop resistance is 0.028Ω
⑺. ---Alarm function activated, the measured current exceeded
the critical value of alarm setting
---Low battery & voltage is displayed. At this time, it not
guarantee the accuracy of the measurements
---Measured current is 8.40A
---Lock the current value displayed
To Next Page
Loading...
