ETCR ETCR2000E Plus - Function Zoom Table; Function Button Mapping; Operating Method; Booting Up the Device

-14-
VI．Function Zoom Table
Function
Bottom
On/off/delay shutdown
ON/OFF
Lock/cancel display
HOLD
Exit
ON/OFF
Resistance/current measurement/data access
mode
MODE
Lock/cancel display/store/access alarm value
SET
Set critical value/digital select/access the data have
stored
MODE/SET
Delete all the data have stored
SET+MODE
VII. Operating Method
1. Boot up
Boot , DO NOT press the trigger, don’t open jaws, nor
clamp any wire
Boot complete, show “OL Ω”, then press the trigger,
open jaws, clamp the measured wire
Before booting up, the trigger should be pressed for
a couple of times to ensure the jaws are well closed.
Boot, must maintain clamp meter natural resting
state, don’t flip Clamp, don’t be imposed outside
force on the jaw, otherwise cannot guarantee the
accuracy of measurement
Press ON/OFF Key to Boot, first, automated testing LCD, show all
of its symbols (Figure 1). Meanwhile the instrument au-