ETCR ETCR2000E Plus - Data Lock, Release, and Storage

-18-
In setting Alarm Critical Value state, need to press the ON/OFF key
or press the AL key for 3 seconds, exit Alarm Critical Value state,
then continue to measurement.
In the resistance test model, press A key to switch to current test
model.
5．Date Lock/Release/Storage
In test model, press HOLD key to Lock currently displayed value
and HOLD symbol. At the same time, this lock-values as a set of
data followed by auto-ID and store, and then press HOLD key to
cancel the lock, HOLD symbol disappeared, can continue to
measure. Loop operation, can store 99 sets of data. If the memory
is full, blinking display MEM symbol.
Figure 9，Lock measured resistance 0.016Ω, at the same time as
the first 01 sets of data storage.
As indicated in Figure 10, lock the measured current 278mA, and
save it as data unit No.99.
And the memory is full now.
blinking display MEM symbol.
In the Date Access Model, press MEM key to exit, then can lock
and storage the data.
In setting Alarm Critical Value state, need to press the ON/OFF key
or press the AL key for 3 seconds, exit Alarm Critical Value state,
then can lock and storage the data.
Shutdown and then boot up, don’t lose stored data.